WOW Handboard + PF3 Swim Fins + Fin Socks + Heel Savers Bundle

Every Contact Point Covered - WOW 13", PF3, Socks and Fin Savers

The POD WOW 13" Handboard, PF3 Evolution Swim Fins, Neoprene Fin Socks and Fin Savers with Heel Protectors cover every contact point a bodysurfer has with the water. The WOW 13" is a polyurethane handboard with an 18mm concave base and built-in keel fin, a different construction from both the polypropylene Original Classic and the Hand Body Soul® cedar walnut range. The PF3 has the most flexible blade in the PF Series. Its asymmetric shape centres load over the foot, and the fin responds precisely to your movement. The fin socks fine-tune the fit inside the asymmetric foot pocket, and the fin savers and heel protectors secure the connection at the ankle.

POD WOW 13" Bodysurfing Handboard

The WOW 13" measures 330mm and is moulded from polyurethane, balanced to stay light while standing up to years of use. The material has a little give, and it springs back as the wave loads the board. Underneath, an 18mm concave leads into a mono-keel fin that guides the water along the base. That adds to the lift your hand already generates on the face and keeps the board holding your line.

On top, the convex deck fills your palm, so your hand sits naturally, and your wrist stays relaxed through a long session.

Polyurethane won't crack like a harder shell, and it doesn't need the care a timber board does. Take it out whenever the surf's on, whatever the conditions, and rinse it when you get home.

For full product details visit the POD WOW 13" Handboard page.

PF3 Evolution POD Swim Fins

Everything else in this kit is built around the PF3. The socks go inside it, the fin savers attach to it, and the handboard relies on your legs to keep you set on the wave.

The pocket gives the sock a close home. It's asymmetric and moulded to the true outline of a foot, so with a sock inside, the fit is snug and doesn't move under load. From there, the blade takes over. It's the longest and most flexible in the PF Series, and its asymmetric shape keeps the pressure centred over your foot instead of on the toe edge. The fin bends in step with your kick, whether you're lunging for a wave or making small corrections on the face.

Vertical rails, like the PF2, run out to the blade edge. As you ride with your hand planing out front, they hold your legs up in the face, level with the board, instead of letting them drop towards the trough.

For the bodysurfer who wants each move of the legs to show up in the water, especially when timing and position decide the wave, this is the fin.

For full product details visit the PF3 Evolution POD Swim Fins page.

PF3 Evolution Swim Fin Sizing

For the most accurate fit, use the measurements below or the POD Fit Finder on the PF3 product page.

Step 1 - Foot Length and Width

• Small/Medium: 7-8 - Length 24 cm, Width 9 cm
• Medium: 8-9 - Length 25 cm, Width 9.5 cm
• Medium/Large: 9-10 - Length 26 cm, Width 10 cm
• Large: 10-11 - Length 27 cm, Width 10.5 cm
• Measurements are maximum sizes before stretch.
• Natural rubber stretch allowance up to 5 mm for a snug fit

Step 2 - Ankle Strap Width

• Small/Medium: 9.5 cm
• Medium: 10 cm
• Medium/Large: 10.5 cm
• Large: 11 cm
• Measurements are before stretch.
• Strap stretch allowance of 10-15 mm for a secure, non-slip fit
• View the PF3 foot and ankle size chart here

POD Neoprene Fin Socks

A good bodysurfing session can run for hours, and any seam inside a fin sock will show well before the end. The POD 3mm Neoprene Fin Socks have none along the inner arch. A registered stitch-free construction keeps that stretch of neoprene smooth, so it lies flat against the medial arch without rubbing, no matter how many waves you kick into.

Inside the PF3, the sock also sharpens the fit. The asymmetric pocket stretches unevenly by design, following the shape of the foot, and every foot fills it a little differently. The sock closes whatever gaps your foot leaves, so the connection with the fin stays firm where you need it.

Neoprene Fin Sock Sizing

• Medium: 7-9
• Large: 9-10
• Extra Large: 10-12
• Extra Extra Large: 12-14

For full product details visit the POD Neoprene Fin Socks page.

POD Fin Savers and Heel Protectors

An asymmetric pocket like the PF3's hugs the foot closely, but the heel strap can still creep when you twist and roll through a wave. The heel protectors stop that. Soft neoprene pads wrap around the fin strap and hold it steady against your heel. They also end the chafing that bare rubber causes over a long session.

The fin savers work as the backstop. A single streamlined ONE-Strap runs from your ankle to the rubber fin strap. If the shore break tears a fin loose, it stays tethered to you rather than washing up on the beach. One slim strap keeps the whole arrangement light, without the bulk and drag of a wider webbing system.

For full product details visit the POD Swim Fin Savers and Heel Protectors page.

Care - Handboard and Swim Fins

• Fresh water rinse after every surf - handboard, fins, socks, and savers
• Shade dry only - avoid direct sunlight for extended periods
• Avoid direct heat - never leave gear inside a vehicle on a hot day
• Store correctly - lay the WOW handboard flat and keep fins upright to maintain shape