POD®

WOO Handboard 12inch + PF3 POD Swim Fins Bodysurfing Bundle

0
(No reviews yet) Write a Review
£122.45 - £130.44

Adding to cart… The item has been added
SKU:
WOOPF3
Weight:
0.90 KGS
Shipping:
Calculated at Checkout
Board Craft:
Sustainable Cedar & Walnut Timber
Lift Dynamics:
90kg Force - Deep 18mm Concave
Hydro Dynamics:
Integrated Keel Fin & Convex Deck
Fin Material:
Natural Floating Rubber (No Fillers)
Evolution Flippers:
PF3 Asymmetric Flex & Vertical Rails

The Bodysurfer's Board. Maximum Flex. A Natural Pairing.

The POD WOO Cedar Walnut Handboard and PF3 Evolution Swim Fins pair the mid-size wood handboard in the Hand Body Soul® range with the most flexible fin in the PF Series. The WOO at 300mm suits a wide range of conditions and riders. The PF3's asymmetric blade centres load over the foot, gives the most flex of the three PF models, and responds precisely to how the rider moves. Together they suit bodysurfers who want more from both contact points without moving to the largest board in the range.

WOO Cedar Walnut Handboard - Hand Body Soul®

The WOO is the mid-size handboard in the Hand Body Soul® range at 300mm (12 inches). The cedar and walnut construction delivers an 18mm concave bottom with integrated keel fin, balancing surface area and control across a wide range of wave sizes and conditions. The convex deck supports a natural hand position in the palm.

WOO Handboard Specifications

  • Volume: 705cm³ (705ml / 0.1862 US liquid gallon)
  • Lifting force: up to 90kg / 198.4lb
  • Size: L 300mm (12") x W 210mm (8.25") x D 43mm (1.69")
  • Deck: Convex with palm hold and support
  • Bottom: 18mm concave with keel fin

For full product details visit the WOO Cedar Walnut Handboard page.

PF3 Evolution POD Swim Fins

The PF3 Evolution is the longest fin in the POD PF Series and the most flexible. The asymmetric blade centres load over the foot rather than the toe edge, moving with the body more naturally through each kick. Like the PF2, the PF3 carries vertical rails that extend to the blade edge, improving wave hold and keeping the legs from sliding down the wave face. The asymmetric foot pocket follows the natural contour of the foot for a precise connection under load.

The PF3 suits experienced bodysurfers and bodyboarders who want a fin that responds precisely to how they move, particularly in conditions where timing, direction, and wave positioning matter most. Available in sizes SM through L.

For full product details visit the PF3 Evolution POD Swim Fins page.

PF3 Evolution Swim Fin Sizing

For the most accurate fit, use the measurements below or the POD Fit Finder on the PF3 product page.

Step 1 - Foot Length and Width

  • Small/Medium: 7-8 - Length 24 cm, Width 9 cm
  • Medium: 8-9 - Length 25 cm, Width 9.5 cm
  • Medium/Large: 9-10 - Length 26 cm, Width 10 cm
  • Large: 10-11 - Length 27 cm, Width 10.5 cm
  • Measurements are maximum sizes before stretch.
  • Natural rubber stretch allowance up to 5 mm for a snug fit

Step 2 - Ankle Strap Width

  • Small/Medium: 9.5 cm
  • Medium: 10 cm
  • Medium/Large: 10.5 cm
  • Large: 11 cm
  • Measurements are before stretch.
  • Strap stretch allowance of 10-15 mm for a secure, non-slip fit
  • View the PF3 foot and ankle size chart here

Care - Wood Handboard and Swim Fins

  • Fresh water rinse after every surf
  • Shade dry only to protect timber and rubber
  • Avoid direct heat to prevent warping or cracking - store out of direct sun and hot vehicles
  • Recoat when needed with a marine-grade satin finish to keep the wood sealed

Heat warning - do not leave wood handboard or fins in sun or hot car

POD fins are manufactured for use within the stated and engraved size range. Using a size more than one size below the specified size alters the intended foot-to-blade ratio and may result in an improper fit or reduced function. Fitting fins to feet larger than the stated size may cause overstretching or overloading, which can compromise the structural integrity of the fin. Such misuse voids warranty coverage. POD rubber fins are made for swimming and are not intended for walking or running. Bending or flexing the blade beyond 35° in any direction may cause tearing or cracking of the blade or sole. Damage resulting from such actions is not covered under warranty. To minimise the risk of damage when moving in shallow water, fins should be used for swimming only. Avoid walking or running forward while wearing fins. Where movement on land or in shallow water is necessary, walking backwards will help prevent undue stress to the blade and foot cavity. This warranty does not affect your rights under the Australian Consumer Law.

Related Products

An relatable roduct