Fins in the Bag. Everything Else Stays Dry.

The POD 25L Waterproof Backpack and PF1 Swim Fins suit swimmers, bodysurfers, and bodyboarders who need to carry wet gear after a session. The fins go in the bag alongside the wetsuit and towel. The roll-top seal keeps everything else dry in transit. Two products that address different parts of the same day at the water.

POD Waterproof Backpack 25L

The POD 25L is made from heavy-duty PVC tarpaulin with electronically heat-welded seams. The main compartment holds 25 litres and seals with a dual-option roll-top closure. Roll the webbing forward three times to create an airtight, watertight seal, then secure with either the top buckle for quick access or the side compression straps for longer carry. The bag floats when sealed correctly.

An IPX6-rated zipper front pocket protects valuables and phones. Padded shoulder straps, an adjustable chest strap, a ventilated back panel, a carry handle, and two D-ring attachment points complete the carry system. Available in Black/Black, Black/Green, Black/Orange, Black/White, and Black/Yellow.

Backpack Dimensions

Height: 48cm after 3 x roll closure
Width: 32cm
Depth: 17cm
Capacity: 25 litres
Weight: 0.60kg

For full product details visit the POD Waterproof Backpack 25L page.

PF1 POD Swim Fins

The PF1 is the lightest fin in the POD PF Series. Made from natural Malaysian buoyant rubber, it uses a streamlined rail that flows into the blade without vertical top rails. That structure gives the blade more natural flex, making each kick more forgiving and easier to sustain. The symmetrical blade and Splay Rails® support balanced movement and stable, controlled progress through the water.

The PF1 suits pool training, open-water swimming, and ocean use across bodysurfing, bodyboarding, and kneeboarding.

For full product details visit the PF1 POD Swim Fins page.

PF1 Swim Fin Sizing

For the most accurate fit, use the measurements below or the POD Fit Finder on the PF1 product page.

Step 1 - Foot Length and Width

Small: 6-7 - Length 23 cm, Width 8.5 cm
Small/Medium: 7-8 - Length 24 cm, Width 9 cm
Medium: 8-9 - Length 25 cm, Width 9.5 cm
Medium/Large: 9-10 - Length 26 cm, Width 10 cm
Large: 10-11 - Length 27 cm, Width 10.5 cm
Extra Large: 11-12 - Length 28 cm, Width 11 cm
Measurements are maximum sizes before stretch.
Natural rubber stretch allowance up to 5 mm for a snug fit

Step 2 - Ankle Strap Width

Small: 8.2 cm
Small/Medium: 8.7 cm
Medium: 9.3 cm
Medium/Large: 9.5 cm
Large: 10 cm
Extra Large: 10.5 cm
Measurements are before stretch.
Strap stretch allowance of 10-15 mm for a secure, non-slip fit
View the PF1 foot and ankle size chart here

POD fins are manufactured for use within the stated and engraved size range. Using a size more than one size below the specified size alters the intended foot-to-blade ratio and may result in an improper fit or reduced function. Fitting fins to feet larger than the stated size may cause overstretching or overloading, which can compromise the structural integrity of the fin. Such misuse voids warranty coverage. POD rubber fins are made for swimming and are not intended for walking or running. Bending or flexing the blade beyond 35° in any direction may cause tearing or cracking of the blade or sole. Damage resulting from such actions is not covered under warranty. To minimise the risk of damage when moving in shallow water, fins should be used for swimming only. Avoid walking or running forward while wearing fins. Where movement on land or in shallow water is necessary, walking backwards will help prevent undue stress to the blade and foot cavity. This warranty does not affect your rights under the Australian Consumer Law.