POD®

PF2 Swim Fins + Bodyboard Bicep Leash POD Connection Bundle

0
(No reviews yet) Write a Review
$116.08 - $158.85

Adding to cart… The item has been added
SKU:
PF2PCBL
Availability:
Usually dispatch within 48 hours
Weight:
1.28 KGS
Shipping:
Calculated at Checkout
Bodyboard Fins:
PF2 Boost - Natural Floating Rubber
Foot Pocket Tech:
Sole Step-Up & Ramp Boost Design
Flippers:
High-Thrust Symmetric Blade
Durability:
Advanced POD Connectors
Leash Hardware:
316 Stainless Steel Buckle & Swivel Shaft

Fins for the Drive. Leash for the Connection. The Bodyboarder's Bundle.

The POD PF2 Swim Fins and Bodyboard Bicep Leash pair two pieces of bodyboarding equipment that work the same session. The PF2 fins provide drive and wave hold with vertical rails that keep the legs stable on the wave face. The POD Connection bicep leash keeps the board connected through wipeouts - an organic over-moulded urethane design that stretches in straight alignment with the cord rather than twisting under load. Available in three bicep sizes.

PF2 POD Swim Fins

The PF2 is the most structured fin in the POD PF Series. Made from natural Malaysian buoyant rubber, it carries vertical rails that extend to the blade edge, improving wave hold and keeping the legs from sliding down the wave face. The sole ramp-up reduces unnecessary toe movement and improves comfort under load. The symmetric Chisel Blade® and Splay Rails® distribute load evenly and support controlled, directed movement through the water. The Sic Cut® design reduces bulk while the Tread Rails® add structural strength along the outside of the foot pocket. Drainage channels allow quick release of water and sand.

The PF2 suits bodyboarding, bodysurfing, swimming, kneeboarding, lifesaving, and ocean photography across a wide range of conditions.

For full product details visit the PF2 POD Swim Fins page.

PF2 Swim Fin Sizing

For the most accurate fit, use the measurements below or the POD Fit Finder on the PF2 product page.

Step 1 - Foot Length and Width

  • Small: 6-7 - Length 23 cm, Width 8.5 cm
  • Small/Medium: 7-8 - Length 24 cm, Width 9 cm
  • Medium: 8-9 - Length 25 cm, Width 9.5 cm
  • Medium/Large: 9-10 - Length 26 cm, Width 10 cm
  • Large: 10-11 - Length 27 cm, Width 10.5 cm
  • Extra Large: 11-12 - Length 28 cm, Width 11 cm
  • Measurements are maximum sizes before stretch.
  • Natural rubber stretch allowance up to 5 mm for a snug fit

Step 2 - Ankle Strap Width

  • Small: 8.2 cm
  • Small/Medium: 8.7 cm
  • Medium: 9.3 cm
  • Medium/Large: 9.5 cm
  • Large: 10 cm
  • Extra Large: 10.5 cm
  • Measurements are before stretch.
  • Strap stretch allowance of 10-15 mm for a secure, non-slip fit
  • View the PF2 foot and ankle size chart here

POD Connection Bodyboard Bicep Leash

The POD Connection uses an organic over-moulded urethane design fused directly onto the urethane cord. Standard connectors use perpendicular slots or angled grooves that twist the cord under load. The POD Connection eliminates those angles entirely, keeping the stretch on a true linear path. When tested, the cord stretched up to six times its original length, distributing load evenly without kinking at the join.

The padded 4mm neoprene bicep cuff is secured with a marine-grade stainless steel buckle and split ring. A marine-grade stainless steel swivel housed in a self-lubricating barrel casing rotates freely and resists salt corrosion. A D-loop allows quick pull-release when needed.

Available Bicep Cuff Sizes

  • Medium bicep: 22cm to 30cm
  • Large bicep: 31cm to 35cm
  • Extra Large bicep: 36cm to 41cm

For full product details visit the POD Bodyboard Leash page.

POD fins are manufactured for use within the stated and engraved size range. Using a size more than one size below the specified size alters the intended foot-to-blade ratio and may result in an improper fit or reduced function. Fitting fins to feet larger than the stated size may cause overstretching or overloading, which can compromise the structural integrity of the fin. Such misuse voids warranty coverage. POD rubber fins are made for swimming and are not intended for walking or running. Bending or flexing the blade beyond 35° in any direction may cause tearing or cracking of the blade or sole. Damage resulting from such actions is not covered under warranty. To minimise the risk of damage when moving in shallow water, fins should be used for swimming only. Avoid walking or running forward while wearing fins. Where movement on land or in shallow water is necessary, walking backwards will help prevent undue stress to the blade and foot cavity. This warranty does not affect your rights under the Australian Consumer Law.

Videos Hide Videos Show Videos

Related Products

An relatable roduct