More Structure in the Water. The Same Bag Gets You There.

The POD 25L Waterproof Backpack and PF2 Swim Fins suit swimmers, bodysurfers, and bodyboarders who want a more structured fin for ocean use. The PF2's vertical rails hold position on the wave face and keep the legs stable through demanding conditions. The backpack carries the fins, wetsuit, and towel to and from the water - sealed against water, sand, and impact. Two products that address different parts of the same day at the ocean.

POD Waterproof Backpack 25L

The POD 25L is made from heavy-duty PVC tarpaulin with electronically heat-welded seams. The main compartment holds 25 litres and seals with a dual-option roll-top closure. Roll the webbing forward three times to create an airtight, watertight seal, then secure with either the top buckle for quick access or the side compression straps for longer carry. The bag floats when sealed correctly.

An IPX6-rated zipper front pocket protects valuables and phones. Padded shoulder straps, an adjustable chest strap, a ventilated back panel, a carry handle, and two D-ring attachment points complete the carry system. Available in Black/Black, Black/Green, Black/Orange, Black/White, and Black/Yellow.

Backpack Dimensions

Height: 48cm after 3 x roll closure
Width: 32cm
Depth: 17cm
Capacity: 25 litres
Weight: 0.60kg

For full product details visit the POD Waterproof Backpack 25L page.

PF2 POD Swim Fins

The PF2 is the most structured fin in the POD PF Series. Made from natural Malaysian buoyant rubber, it carries vertical rails that extend to the blade edge, improving wave hold and keeping the legs from sliding down the wave face. The sole ramp-up reduces unnecessary toe movement and improves comfort under load. The symmetric Chisel Blade® and Splay Rails® distribute load evenly and support controlled, directed movement through the water.

The PF2 suits swimming, open-water training, bodysurfing, bodyboarding, kneeboarding, lifesaving, and ocean photography across a wide range of conditions.

For full product details visit the PF2 POD Swim Fins page.

PF2 Swim Fin Sizing

For the most accurate fit, use the measurements below or the POD Fit Finder on the PF2 product page.

Step 1 - Foot Length and Width

Small: 6-7 - Length 23 cm, Width 8.5 cm
Small/Medium: 7-8 - Length 24 cm, Width 9 cm
Medium: 8-9 - Length 25 cm, Width 9.5 cm
Medium/Large: 9-10 - Length 26 cm, Width 10 cm
Large: 10-11 - Length 27 cm, Width 10.5 cm
Extra Large: 11-12 - Length 28 cm, Width 11 cm
Measurements are maximum sizes before stretch.
Natural rubber stretch allowance up to 5 mm for a snug fit

Step 2 - Ankle Strap Width

Small: 8.2 cm
Small/Medium: 8.7 cm
Medium: 9.3 cm
Medium/Large: 9.5 cm
Large: 10 cm
Extra Large: 10.5 cm
Measurements are before stretch.
Strap stretch allowance of 10-15 mm for a secure, non-slip fit
View the PF2 foot and ankle size chart here

POD fins are manufactured for use within the stated and engraved size range. Using a size more than one size below the specified size alters the intended foot-to-blade ratio and may result in an improper fit or reduced function. Fitting fins to feet larger than the stated size may cause overstretching or overloading, which can compromise the structural integrity of the fin. Such misuse voids warranty coverage. POD rubber fins are made for swimming and are not intended for walking or running. Bending or flexing the blade beyond 35° in any direction may cause tearing or cracking of the blade or sole. Damage resulting from such actions is not covered under warranty. To minimise the risk of damage when moving in shallow water, fins should be used for swimming only. Avoid walking or running forward while wearing fins. Where movement on land or in shallow water is necessary, walking backwards will help prevent undue stress to the blade and foot cavity. This warranty does not affect your rights under the Australian Consumer Law.