Protect the Board Between Sessions. Drive It Through the Wave.
The POD Bodyboard Stretch Covers and PF2 Swim Fins pair equipment for two different parts of the bodyboarding day. The stretch cover protects the board between sessions - 320gsm recycled knit fabric that guards against scratches and deck wear during transport and storage. The PF2 fins drive the bodyboarder through the wave during the session, with vertical rails that keep the legs stable on the wave face. Available in four cover colours and a full range of fin sizes.
POD Bodyboard Stretch Covers
The POD Bodyboard Stretch Cover is made from 320 grams per square metre of recycled stretch knit fabric. The tight-knit construction protects the board surface from scratches and everyday deck wear during transport and storage. A drawstring with a barrel lock secures the opening and a protective panel reinforces the closure point.
The cover fits bodyboards up to 1.12m / 44 inches in length, and stretches to accommodate various board widths. A soft-lined internal accessories pocket protects phones and small valuables from scratches.
The POD® brand mark appears on the inside of the cover rather than the outside. That is a deliberate choice - to avoid any conflict of interest with the bodyboarder's preferred board brand. The branding sits alongside the board where it is relevant, not on display on the outside.
Available in Lime, Orange, POD Blue, and Yellow.
For full product details visit the POD Bodyboard Stretch Covers page.
PF2 POD Swim Fins
The PF2 is the most structured fin in the POD PF Series. Made from natural Malaysian buoyant rubber, it carries vertical rails that extend to the blade edge, improving wave hold and keeping the legs from sliding down the wave face. The sole ramp-up reduces unnecessary toe movement and improves comfort under load. The symmetric Chisel Blade® and Splay Rails® distribute load evenly and support controlled, directed movement through the water.
The PF2 suits bodyboarding, bodysurfing, swimming, kneeboarding, lifesaving, and ocean photography across a wide range of conditions. Available in variegated Black/White and Black/Yellow colour options.
For full product details visit the PF2 POD Swim Fins page.
PF2 Swim Fin Sizing
For the most accurate fit, use the measurements below or the POD Fit Finder on the PF2 product page.
Step 1 - Foot Length and Width
- Small: 6-7 - Length 23 cm, Width 8.5 cm
- Small/Medium: 7-8 - Length 24 cm, Width 9 cm
- Medium: 8-9 - Length 25 cm, Width 9.5 cm
- Medium/Large: 9-10 - Length 26 cm, Width 10 cm
- Large: 10-11 - Length 27 cm, Width 10.5 cm
- Extra Large: 11-12 - Length 28 cm, Width 11 cm
- Measurements are maximum sizes before stretch.
- Natural rubber stretch allowance up to 5 mm for a snug fit
Step 2 - Ankle Strap Width
- Small: 8.2 cm
- Small/Medium: 8.7 cm
- Medium: 9.3 cm
- Medium/Large: 9.5 cm
- Large: 10 cm
- Extra Large: 10.5 cm
- Measurements are before stretch.
- Strap stretch allowance of 10-15 mm for a secure, non-slip fit
- View the PF2 foot and ankle size chart here
