Compact and Agile. Vertical Rail Drive. The Technical Rider's Pairing.

The POD EGO Cedar Walnut Handboard and PF2 Swim Fins pair the smallest wood handboard in the Hand Body Soul® range with the most structured fin in the PF Series. The EGO at 225mm suits technical surf, smaller hands, and riders who prefer a compact, agile contact point in the water. The PF2's vertical rails keep the legs stable on the wave face. Two products chosen for control and precision, paired in one purchase.

EGO Cedar Walnut Handboard - Hand Body Soul®

The EGO is the smallest handboard in the Hand Body Soul® range at 225mm (9 inches). The cedar and walnut construction delivers a 16mm concave bottom with integrated keel fin. The convex deck supports a natural hand position in the palm with ergonomic palm hold and support. The compact size suits technical surf, steeper waves, and riders with smaller hands.

EGO Handboard Specifications

Volume: 485cm³ (485ml / 0.1281 US liquid gallon)
Lifting force: up to 70kg / 154.3lb
Size: L 225mm (9") x W 200mm (7.87") x D 41mm (1.61")
Deck: Convex with palm hold and support
Bottom: 16mm concave with keel fin

For full product details visit the EGO Cedar Walnut Handboard page.

PF2 POD Swim Fins

The PF2 is the most structured fin in the POD PF Series. Made from natural Malaysian buoyant rubber, it carries vertical rails that extend to the blade edge, improving wave hold and keeping the legs from sliding down the wave face. The sole ramp-up reduces unnecessary toe movement and improves comfort under load. The symmetric Chisel Blade® and Splay Rails® distribute load evenly and support controlled, directed movement through the water.

The PF2 suits swimming, open-water training, bodysurfing, bodyboarding, kneeboarding, lifesaving, and ocean photography across a wide range of conditions.

For full product details visit the PF2 POD Swim Fins page.

PF2 Swim Fin Sizing

For the most accurate fit, use the measurements below or the POD Fit Finder on the PF2 product page.

Step 1 - Foot Length and Width

Small: 6-7 - Length 23 cm, Width 8.5 cm
Small/Medium: 7-8 - Length 24 cm, Width 9 cm
Medium: 8-9 - Length 25 cm, Width 9.5 cm
Medium/Large: 9-10 - Length 26 cm, Width 10 cm
Large: 10-11 - Length 27 cm, Width 10.5 cm
Extra Large: 11-12 - Length 28 cm, Width 11 cm
Measurements are maximum sizes before stretch.
Natural rubber stretch allowance up to 5 mm for a snug fit

Step 2 - Ankle Strap Width

Small: 8.2 cm
Small/Medium: 8.7 cm
Medium: 9.3 cm
Medium/Large: 9.5 cm
Large: 10 cm
Extra Large: 10.5 cm
Measurements are before stretch.
Strap stretch allowance of 10-15 mm for a secure, non-slip fit
View the PF2 foot and ankle size chart here

Care - Wood Handboard and Swim Fins

Fresh water rinse after every surf
Shade dry only to protect timber and rubber
Avoid direct heat to prevent warping or cracking - store out of the sun and hot car boots
Recoat when needed with a marine-grade satin finish to keep the wood sealed

Heat warning - do not leave wood handboard or fins in sun or hot car

POD fins are manufactured for use within the stated and engraved size range. Using a size more than one size below the specified size alters the intended foot-to-blade ratio and may result in an improper fit or reduced function. Fitting fins to feet larger than the stated size may cause overstretching or overloading, which can compromise the structural integrity of the fin. Such misuse voids warranty coverage. POD rubber fins are made for swimming and are not intended for walking or running. Bending or flexing the blade beyond 35° in any direction may cause tearing or cracking of the blade or sole. Damage resulting from such actions is not covered under warranty. To minimise the risk of damage when moving in shallow water, fins should be used for swimming only. Avoid walking or running forward while wearing fins. Where movement on land or in shallow water is necessary, walking backwards will help prevent undue stress to the blade and foot cavity. This warranty does not affect your rights under the Australian Consumer Law.